|
Audi S4since 2000 releaseRepair and operation of the car |
|
Audi S4 + Introduction - Governing bodies and methods of safe operation Governing bodies and devices Information system of the driver (FIS) Unlocking and locking of the car Lighting and providing review Seats and niches Heater, ventilation and conditioner of air Automatic Transmission (AT) Communication and navigation Universal remote radio control of HOME LINK® Security systems Features of operation and auxiliary systems Running in Towage of the trailer In case of emergency Gas station of the car + Current leaving and service + Engine + Cooling systems, heating and air conditioner + Power supply systems, release and decrease in toxicity of the fulfilled gases + Systems of electric equipment of the engine + Manual box of gear shifting + Automatic transmission + Coupling, power shafts and differential + Brake system + Suspension bracket and steering + Body + Onboard electric equipment |
Governing bodies and devices
The arrangement of some controls of cars with right-hand steering differs from shown on an illustration. However the symbols used for their designation correspond to symbols of cars with left-side steering. Central console
The arrangement of some controls of cars with right-hand steering differs from shown on an illustration. However the symbols used for their designation correspond to symbols of cars with left-side management. In case of a factory complete set of the car the system of navigation Audi plus and the Audi symphony radio system to them attaches the corresponding operation manual. In system of navigation Audi plus of function of radio, the CD player and TV * are built-in. Control panel The control panel serves the driver as information center of the car.
Index of temperature of cooling liquid The index of temperature of cooling liquid works only at the included ignition. In order to avoid damages of the engine take the following instructions of rather temperature conditions into account.Interval of temperatures of the cold engine If the arrow still is in the left part of a scale, then it means that the engine did not reach working temperature yet. Avoid the raised turns, "full gas" and considerable loading of the engine.Working temperature The engine reached working temperature if at the normal mode of the movement of the shooter of the index of temperature is in limits of a middle part of a scale. At considerable loading of the engine and high temperature of external air of the shooter can depart further to the right on a scale. It should not become a reason for alarm until on the display of the control panel the alarm symbol lights up The blinking of an alarm symbol on the display demonstrates falling of level of cooling liquid or its overheat, cm. Information system of the driver (FIS). Additional headlights and other hinged components interfering a supply of the cooling air worsen effect of cooling of cooling liquid. At the high external temperature and considerable loading of the engine in this case there is a danger of an overheat of the engine! One of problems of a forward spoiler during the movement is the correct distribution of the cooling air. At damage of a spoiler the cooling effect worsens and there is a danger of an overheat of the engine! Use the qualified help. Tachometer The tachometer shows the frequency of rotation of the crankshaft of the engine. With a frequency of rotation less than 1500 revolutions per minute it is necessary to switch to the following low gear. The beginning of the red sector of a scale corresponds for all transfers to the range of the maximum turns, admissible is short-term for the rolled and heated-up engine. It is necessary to switch to an overgear, to install the selector lever in situation "D" or to reduce gas until achievement by an arrow of this sector of a scale. Only short-term calling of an arrow of a tachometer on the red sector of a scale is allowed - there is a danger of damage of the engine! The beginning of a red scale depends on version of the engine. Preliminary switching to overgears will help you to save fuel and to reduce operational noise! Digital watch with indication of date — digital watch The car is completed with the quartz watch or clock radios. Installation of hours PERFORMANCE ORDER Installation of minutes PERFORMANCE ORDER Installation of calendar date PERFORMANCE ORDER Switching off of calendar date PERFORMANCE ORDER Call of calendar date PERFORMANCE ORDER The termination of a blinking of indication after pressing of the button means completion of process of installation and programming of time / calendar date. Pressing of the CHECK button, at the switched-off ignition it is possible to turn on for several seconds the digital watch with indication of date and the run counter. Clock radios In the "radio-controlled quartz watch" mode on the display panel there is a symbol of reception of radio of information (radio a tower with the dispersing waves). In this mode manual change of indication of minutes and date is impossible. In various time zones it is necessary to change indication of hours manually respectively. In the absence of the corresponding radio signal within three days, hours automatically switch in the "quartz watch" mode. At the same time indication of a symbol of reception of radio of information disappears. In need of new installation of time and calendar date address subsection the Digital watch with indication of date. Lighting of devices PERFORMANCE ORDER The phototransistor installed in the control panel regulates lighting of devices (illumination of arrows and scales), lighting of the central console and lighting of displays. At vyklyuchyonny light and the included ignition devices are lit (shooters and scales). With decrease in brightness of a surrounding background brightness of lighting of devices automatically decreases. At insignificant surrounding light lighting in general is turned off. This function serves to the driver as a reminder of timely inclusion of passing beam at decrease in brightness of a surrounding background. Speedometer, counter of the general run and measuring instrument of a run Speedometer The speedometer shows speed. Fragment of the control panel: counter and measuring instrument of a run, CHECK button Indication of a run is removed in kilometers (km). In some modifications indication is removed in miles. The counter of the general run (is below) Registers the general run of the car in kilometers or miles. The run measuring instrument (is from above) Registers a run from the moment of the last dumping of its indication. It allows to measure certain pieces of a run. The price of division of the measuring instrument makes 100 m or 1/10 miles. Dumping (installation of zero value) is carried out by pressing of the button of dumping. Display of faults About existence of malfunction in the control panel indication of "dEF" on the display of the measuring instrument of a run signals. Index of a reserve of fuel The index works only at the included ignition. Capacity of the fuel tank is specified in Specifications. If the arrow reached the reserve field, then on the display of the control panel, cm. The information system of the driver (FIS) lights up a symbol Never run out of fuel completely! Irregular supply of fuel can lead to interruptions in system of ignition. As a result not burned down fuel will get to system of production of the fulfilled gases. It can lead to an overheat and damage of the catalytic converter CHECK button Functional purpose of the CHECK button: Inclusion of indication of the digital watch, counter and measuring instrument of a run Pressing of the CHECK button, at the switched-off ignition, for several seconds the display of the digital watch, with indication of date, and run displays turn on. Inclusion of function of the control system of malfunctions of the car (AutochekControl) At the included ignition and during the movement system of automatic control of malfunctions, cm. The information system of the driver (FIS) continuously controls certain functions and technical condition of systems of the car. At the included ignition function of the control system of malfunctions can be included also pressing of the CHECK button. Check of work of system can be performed both at muffled, and at the working engine and at a speed no more than 5 km/h. Conclusion to indication of instructions to the driver At a blinking on the display of any symbol of the 1st degree of a priority, cm. An information system of the driver (FIS) or at emergence of the indication informing on malfunction of function of lamps, cm. An information system of the driver (FIS), short-term pressing of the CHECK button the driver can include illumination of the corresponding instruction again. For example: Motor abstellen, Olstand prufen (to kill the engine, to check oil level). Indication of the display dies away approximately in 5 seconds. Speeding alarm system Pressing of the CHECK button during the movement it is possible to program threshold value of degree of the prevention of 1 device of the alarm system of speeding, cm. Information system of the driver (FIS), "Degree of the prevention 1: function". Threshold value of degree of the prevention 2 * devices of the alarm system of speeding, cm. Information system of the driver (FIS), "Degree of the prevention 2: function" is programmed only at the switched-off ignition. Indication of term of maintenance Indication of term of maintenance reminds of the next servicing. Fragment of the control panel: indication of term of maintenance Maintenance indication Short-term pressing of the button (1) at the included ignition to indication brings the number of kilometers before the forthcoming servicing. A conclusion of indication is possible both at muffled, and at the working engine and at a speed no more than 5 km/h. Indication of number of kilometers before maintenance is staticized every time after inclusion of ignition - the first time through 500 km after dumping. On indication of the display of the new car / car after carrying out maintenance in the period of the first 500 km of a run will be, the message of SERVICE IN — — - KM — - TAGEN is displayed. It extends also to cars with "LongLifeservice". Reminder on maintenance When before the forthcoming servicing there are 2000 and less kilometers, at inclusion of ignition indication is brought to the display: SERVICE IN 2000 km — TAGEN 5 seconds later the display switches to the normal mode of indication. Indication of number of kilometers before servicing is staticized every time after inclusion of ignition, up to approach of term of carrying out maintenance. Approach of term of maintenance At approach of term of passing of the next maintenance directly after inclusion of ignition indication "SERVICE is brought to the display!". 5 seconds later the display switches to the normal mode of indication. Dumping into the provision of new counting of indication Switch off ignition. At the pressed button (1) include ignition. On the display appears one or the other messages: "SERVICE IN — — - KM" or "SERVICE". Press the button of dumping (2) before emergence on the indication display "SERVICE IN — — - KM — - TAGEN" or "SERVICE!". If do not press the dumping button within 5 seconds, the display switches to the normal mode of indication. Dump indication on new counting only after carrying out maintenance. Otherwise it will not be true. At an accumulator detachment these indications of term of maintenance remain. With malfunction of the 1st degree of a priority (a red symbol) the call of indication of number of kilometers before maintenance is impossible. Dumping button The button of dumping "0.0", (2) has the following appointment: Dumping of indications of the measuring instrument of a run Installation of zero value of the measuring instrument of a run (top) is carried out by pressing of the button of dumping. New counting of indication of term of maintenance It is made by pressing of the button of dumping. At the same time indication of term of maintenance has to be in the dumping mode. Control lamps Control lamps of the control panel Control lamps signal about a condition of certain functions / malfunctions.
Control panel: control lamps
A number of functions is controlled by the control system of malfunctions, cm. Information system of the driver (FIS). Functional violations are brought to the display of the control panel as red symbols (a priority 1 - danger) or yellow symbols (a priority 2 - the prevention). Electronics of the engine The control lamp
AIR BAG security systems
The control lamp
of AIR BAG
lights up for several seconds at inclusion of ignition. The system is faulty if the control lamp
of AIR BAG
does not die away after inclusion of ignition or lights up, blinks during the movement, and also does not light up at inclusion of ignition. Electronic anticreeping blocking The control lamp signals about data exchange between the car and the original ignition key. At inclusion of ignition the request of data of a key of the car is automatically made. The positive result of data exchange is confirmed by short fire of a control lamp
When using of a stereotyped key the control lamp begins is long to blink. In this case operation of the car, see Unlocking and locking of the car is impossible. Tempostat The control lamp
Indexes of turn of the trailer At the movement with the trailer the control lamp blinks together with the included indexes of turn. The control lamp
At malfunction of a lamp of the index of turn on the car or the trailer the control lamp does not blink. Device of anti-blocking of the brake system (ABS) The control lamp controls the ABS function and devices of electronic blocking of differential (EDS). The control lamp The ABS device is faulty if: In this case braking of the car only with use of the ordinary brake system, i.e. without ABS is possible. Immediately address on HUNDRED. In more detail concerning ABS, see Features of operation and auxiliary systems. At malfunction of ABS the control lamp of ESP burns.
Malfunction of all brake system If the control lamp of ABS In case of functional violation of the brake system on the display of the control panel the symbol appears
Malfunction of the device of electronic blocking of differential (EDS) The EDS device works together with ABS. About failure of the EDS device fire of a control lamp of ABS signals Reminder on need to be fastened The control lamp reminds of not fastened seat belt. The control lamp In more detail concerning seat belts, see Security systems. Indexes of turn The control lamp blinks together with the included indexes of turn. Depending on the included indexes of turn the left
At refusal of one of indexes of turn the control lamp blinks twice more often. Told does not belong to the movement with the trailer. At malfunction of any lamp of the index of turn on the car or the trailer the control lamp does not blink. In more detail concerning indexes of turn, see Lighting and providing the review. Category of the accumulator The control lamp signals about defect of the generator or malfunction of electric equipment of the car. The control lamp
If the lamp
Fire in the control panel during the movement of in addition alarm symbol
Driving beam The control lamp burns at the included driving beam. The control lamp
In more detail rather driving beam, cm. Information system of the driver (FIS). Parking fires
The control lamp burns at the included parking fires. The control lamp
Brake system The control lamp blinks at too low level of brake fluid, malfunction of the ABS device or at the tightened emergency brake. In case of a blinking of a control lamp
At ABS refusal the control lamp of ABS
The tightened emergency brake The control lamp
Cars with ESP Electronic antistrange system (ESP) The control lamp monitors function of electronic antistrange system. Functions of a control lamp: The lamp blinks during the movement during the operation of the ESP device. The lamp lights up for control of function at inclusion of ignition and has to go out approximately in 2 seconds. The lamp burns at malfunction of ESP. The lamp burns after shutdown and the subsequent connection of the accumulator. The lamp burns at the switched-off ESP device. The lamp burns also at ESP refusal as the ESP device works together with ABS. At fire of a control lamp right after start of the engine there can be a protective shutdown of ESP caused by system. In this case you can include ESP switching off and the subsequent inclusion of ignition. The lamp dies away and the device is completely ready for operation. In case of shutdown and the subsequent connection of the accumulator the control lamp lights up after inclusion of ignition. That the lamp went out, rather short movement on a straight line. In more detail concerning ESP, see Features of operation and auxiliary systems. Cars with the petrol engine Management of EPC engine capacity The control lamp watches a control system of the engine. The control lamp of EPC (Electronic Power Control) lights up for several seconds at inclusion of ignition, for demonstration of the working capacity. Fire of a control lamp during the movement testifies to malfunction in a control system of the engine. Urgently carry out the required inspections of the engine. Cars with the diesel engine System of preheat Fire of a control lamp testifies to preheat of the engine. You start the engine at once as soon as the lamp, see Features of operation and auxiliary systems goes out. At start of the heated-up engine, and also at an external temperature above +8 °C the control lamp lights up approximately for 1 second. Fire of a control lamp of system of preheat during the movement testifies to malfunction in a control system of the engine. The engine needs urgent check. The reason that the control lamp at inclusion of ignition does not light up, maybe, malfunction in system of preheat at all. The engine needs check. |