Audi S4

since 2000 release

Repair and operation of the car



Audi S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
- Brake system
   Specifications
   Removal of air from the brake system
   Removal and installation of front brake shoes
   Removal and installation of blocks of brake mechanisms of back wheels
   Check of thickness of a brake disk
   Removal and installation of a brake disk / support
   Adjustment of the parking brake
   Removal and installation of the switch of a stoplight
   Removal and installation of a brake hose
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Check of thickness of a brake disk

 PERFORMANCE ORDER

  1. Mark with an arrow the direction of rotation of a wheel. Turn off bolts of fastening of wheels. Lift and install the car on supports.
  1. Measure thickness of a brake disk surely in the thinnest place (an arrow on an accompanying illustration). On HUNDRED for this purpose there is a special caliper or a micrometric bracket since wear of a disk has an edge. It is possible to measure thickness of a disk by means of a usual caliper. In this case on each party of a brake disk it is necessary to put laying of a certain thickness (for example, a small coin). In this case it is necessary to subtract thickness of two coins from the received result of measurement.

It is necessary to perform measurement in several points of a brake disk.

  1. The sizes of a brake disk are specified in Specifications.
  1. If the limit of wear of a disk is reached, it is necessary to replace surely both disks of one axis.
  1. In the presence of big cracks or flutes, more than 0.5 mm in depth the brake disk needs to be replaced.
  1. Observing the direction of rotation, establish a wheel and fix it. Lower the car on wheels and only after that tighten bolts of fastening of a wheel cross-wise the moment of 120 Nanometers.