since 2000 release
Repair and operation of the car
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
- Systems of electric equipment of the engine
+ System of ignition and engine management
- System of preheat of the diesel engine
Removal and installation of candles of an incandescence
Check of candles of an incandescence
+ Diagnostics of systems of electronic control and diagnostic equipment
+ Systems of charging and start
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
Шпонированный МДФ спб, ск.
System of preheat of the diesel engine
On the cold diesel engine, at compression of air in cylinders, temperature, necessary for fuel spontaneous ignition, is not reached. For this reason preheat is required.
For this purpose in each combustion chamber the glow plug is established. The glow plug consists of the case with a heating core, vpressovanny in it. The heating core in turn consists of a heating spiral and an adjusting spiral. After giving of tension the heating spiral in a core heats up within several seconds to temperature + 850 °C. At the same time the current passing on a candle reaches 30A. At increase in heating spiral resistance increases that limits current to 15 - 25 And. When the control lamp of preheat on the dashboard dies away, the engine can be started.
The preheat time necessary for start of the engine makes no more than 10 pages. Time is regulated by the relay of preheat and the control unit of the engine which via the sensor of temperature of cooling liquid obtains information on the current temperature of the engine. The control unit of the engine on the basis of the obtained information makes the decision on duration of inclusion of candles of an incandescence and necessary current of heating.