Audi S4

since 2000 release

Repair and operation of the car



Audi S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures when carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   + External equipment
   - Equipment of salon
      Remarks on work with the equipment of salon and a security measure
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of the parking brake
      Removal and installation of a cover of the lever of switching of transfers/selector
      Removal and installation of an ashtray
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and installation of a cover on the control panel
      Removal and installation of a pocket from the driver
      Removal and installation of a ware box
      Removal and installation of an antisolar peak
      Removal and installation of facing are permanent And
      Removal and installation of the top facing of a rack In
      Removal and installation of the lower facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Station wagon)
      Removal and installation of a front seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment





Removal and installation of facing are permanent And

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a safety cushion surely observe security measures at the address with a safety cushion, address the Section General information and security measures.

  1. To exclude operation a head safety cushion, switch off ignition and disconnect at first negative, and then positive cables of the rechargeable battery. Instructions are provided in the Section Replacement of the Rechargeable Battery.
  1. Remove a solar peak, address appropriate section.
 
  1. Press down the handle (5) and cast away a screw cover (4) down. For this purpose enter a thin wire into a groove (7) and open a cover.
  1. Turn out screws (2).
  2. Take out a cover (9) from facing (1) and turn out the screw which is behind it.
  3. Disconnect facing (1) at spring clips (3) grooves (6) in a rack And yes extend under facing of a rack of Century.
  4. Remove from the dashboard facing of a rack A (1) back.

Installation

 PERFORMANCE ORDER

  1. Insert facing under consolidation of a door (8) and press the directing pad (10) in the holder of a clip. At the same time you monitor the correct provision of a sealant of a door.
  2. Press facing at spring clips (3) and record.
  3. Insert facing of a rack And under facing of a rack of Century.
  4. Check that the clip and hooks of the adapter of a safety cushion were reliably recorded.
  5. Screw the screw behind and press a cover (9) into facing.
  6. Fix the handle by the new self-stopped screws (2). Close a screw cover.

During connection of the rechargeable battery in salon there should not be people.

  1. Shoot the insulating film from the negative plug of the rechargeable battery, attach at first positive (+), and then a negative cable (-) to the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.