Audi S4

since 2000 release

Repair and operation of the car



Audi S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures when carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   - External equipment
      Installation of the forward panel in situation for maintenance
      Removal and installation of a cover of a water-collecting compartment
      Removal and installation of a front bumper
      Removal and installation of a loker of a back wing
      Removal and installation of a loker of a forward wing
      Removal and installation of a forward wing
      Removal and installation of a rear bumper
      Removal and installation/adjustment of a cowl
      Removal and installation of a cable of the drive of a cowl
      Removal and installation of a clamp of the lock
      Removal and installation of facing of a forward door
      Removal and installation of facing of a back door
      Removal and installation of a door
      Adjustment of a door
      Removal and installation of a frame of a window of a forward door
      Removal and installation of a window regulator
      Removal and installation of the electric motor of the drive of a window regulator
      Removal and installation of the lock of a door
      Removal and installation of the handle of a door
      Removal and installation of the cylinder of the lock of a door
      Removal and installation of facing of a trunk lid
      Removal, installation and adjustment of a trunk lid
      Removal and installation of the lock of a luggage carrier
      Removal and installation of facing of a door of a back (Station wagon)
      Removal and installation of a door of a back (Station wagon)
      Removal and installation of the lock of a door of a back (Station wagon)
      Removal and installation of an external mirror
      Removal and installation of moldings
      Removal, installation and check of the movable panel of a roof
      Removal and installation of an overlay of the movable panel of a roof
      Check and adjustment of a starting position of the movable panel of a roof
      Removal and installation of a sealant of the movable panel
      Replacement of elastic bands of brushes of a screen wiper
      Removal and installation of a jet of windscreen washer of a windshield
      Removal and installation of a jet of a washer of back glass
      Removal and installation of the lever of screenwash
      Removal and installation of the lever of a cleaner of back glass
      Removal and installation of jets of a faroomyvatel
      Adjustment of levers of a screen wiper
   + Equipment of salon
+ Onboard electric equipment


4affa92a



Removal and installation of facing of a back door

Facing of a door

1 — Facing of a door
2 — the Decorative level
3 — Screws, 4 pieces.
4 — the Cover
5 — the window regulator Handle, the manual drive

6 — the Screw
7 — Razzhimnaya a nut, 4 pieces.
8 — the Tightening nut, 4 pieces.
9 — the window regulator Switch
Depending on the equipment.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

  1. Disconnect a decorative level (2) from facing and remove it forward.
  2. Turn out 4 screws (3).
  3. Manual window regulator: Remove the handle of a window regulator (5).
  4. Enter a plastic wedge around clips between the panel of a door and facing and remove facing from a door.
  5. Take away facing from a frame of a door a little and disconnect a door drive cable, address the Section Removal and installation of facing of a forward door.
  6. Disunite the socket of the switch of a window regulator (9).
  7. Remove facing from a door frame.

Installation

 PERFORMANCE ORDER

  1. Before installation check correctness of provision of tightening nuts (8) and razzhimny nuts (7) on a door frame.
  2. Installation is carried out in the sequence, the return to removal. At the same time pay attention that the hook shows (3) drafts upward.
  3. Manual window regulator: Install into place the window regulator handle.
  4. Attach a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

Window regulator handle

Removal

 PERFORMANCE ORDER

  1. Enter the screw-driver between a cover (4) and the handle of a window regulator.
  2. Uncover the window regulator handle.
  3. Turn out the screw (6) and remove the handle.

Installation

 PERFORMANCE ORDER

  1. Install the window regulator handle in situation "for 6 hours" (± 15 °) at the closed window on a handle axis.